|本期目录/Table of Contents|

[1]毛清国,任晶*,李峻峰,等.催化裂化回炼油制备针状焦[J].石化技术与应用,2024,5:342-345.
　MAO Qing-guo,REN Jing,LI Jun-feng,et al.Preparation of needle coke from fluid catalytic cracking recycle oil[J].Petrochemical technology & application,2024,5:342-345.
点击复制

催化裂化回炼油制备针状焦(PDF)

《石化技术与应用》[ISSN:1009-0046/CN:62-1138/TQ]

期数:
2024年5期
页码:
342-345
栏目:
出版日期:
2024-09-10

文章信息/Info

Title:
Preparation of needle coke from fluid catalytic cracking recycle oil
文章编号:
1009-0045（2024）05-0342-04
作者:
毛清国; 任晶*; 李峻峰; 李新
（辽宁宝来生物能源有限公司，辽宁 盘锦 124000）
Author(s):
MAO Qing-guo; REN Jing; LI Jun-feng; LI Xin
（Liaoning Baolai Bioenergy Co Ltd，Panjin 124000，China）
关键词:
催化裂化回炼油; 针状焦; 糠醛抽提; 抽出油; 釜式焦化
Keywords:
fluid catalytic cracking recycle oil; needle coke; furfural extraction; extract oil; kettle coking
分类号:
TE 624.4+1
DOI:
DOI：10.19909/j.cnki.ISSN1009-0045.2024.05.0342
文献标识码:
B
摘要:
以催化裂化回炼油为原料，先采用糠醛抽提工艺分离得到富含芳烃的抽出油，再通过釜式焦化工艺制备针状焦，并对针状焦的组织结构和抗压碎强度进行分析。结果表明：一次糠醛抽提所得抽出油中3~5环芳烃总质量分数为48.7%，相比于抽提前有所增加；二次糠醛抽提所得抽出油中残炭质量分数为3.3%，3~5环芳烃总质量分数为61.4%，均符合针状焦原料指标要求；以脱固油浆为原料制备的针状焦收率最高，为56.42%；以二次糠醛抽提抽出油为原料制备的针状焦收率为46.28%，满足锂离子电池负极材料使用要求，并且组织结构中镶嵌结构明显减少，流域结构尺寸大，纤维结构占比高，综合性质更佳。
Abstract:
Using fluid catalytic cracking recycle oil as raw materials，the extracted oil rich in aromatics was separated using furfural extraction process，and then used as raw material to prepare needle coke through kettle coking process，and the microstructure and crushing strength of needle coke were analyzed. The results showed that the total mass fraction of three，four，and five ring aromatic hydrocarbons in the extracted oil obtained from a single furfural extraction was 48.7%，which increased compared to the earlier extraction. The residual carbon mass fraction in the extracted oil obtained from secondary furfural extraction was 3.3%，and the total mass fraction of aromatic hydrocarbons in the three，four，and five rings was 61.4%，all of which met the requirements of needle coke raw material indicators. The needle coke prepared from desorbed oil slurry had the highest yield of 56.42%. The yield of needle coke prepared from secondary furfural extraction oil as raw material was 46.28%，which met the requirements of negative electrode materials for lithium-ion batteries. The embedded structure in the microstructure was significantly reduced，the domain structure size was large，the fiber quality was high，and the properties were better.

参考文献/References

［1］ 旷俊杰，杨基和，刘英杰，等.催化裂化回炼油溶剂精制新工艺的研究［J］.精细石油化工，2011，28（6）：52-54.［2］ 李琦，申海平，范启明，等.偏光显微结构分析在针状焦研究中的应用进展［J］.石油化工，2023，52（11）：1632-1640.［3］ 郭启纯.石油系针状焦生产原料的预处理工艺研究［J］.化工管理，2023（17）：123-125.［4］ 张惠芳.加氢-糠醛抽提组合工艺生产芳香基橡胶增塑剂的研究［D］.北京：中国石油大学（北京），2023.

备注/Memo

备注/Memo:
辽宁省科技厅重大专项资助项目（项目编号：2020 JH 1/10100005）
更新日期/Last Update: 2024-09-10